Sheepskin Tailors Care Guide
Hello and welcome to the sheepskin car seat covers care guide from the team at Sheepskin Tailors. We would like to thank you for trusting in our tailor made sheepskin car seat covers.
Now that you have your sheepskin car seat covers, the next step is to fit them.
How to fit
There is a 20cm extension elastic included with a male/female clip at either end. This is to help fit the elastics under your seat where it is hard to get your hands under. It will be left over at the end of the fitting.
First remove the headrest. If your headrest doesn’t come out of the seat there will be an opening in the top of the seat cover that will close with velcro. There is a release button on the plug where the headrest pole goes into the seat. Press the button and pull the headrest out.
The seat covers are labelled “drivers” and “passengers” seat. Start fitting the top part of the seat first, push the plastic plugs on your seat through the headrest holes. On the cover there are three clips on the elastic that go through the crack of the seat – push them through. Then place the base of the seat cover making sure its all fitting into place well, pull the base right back.
There is plenty of sheepskin to go in the gap between the base and top of the seat.
Now raise the seat to its highest position and bring the seat forward as far as it will go. Then kneel down next to the seat one hand at the back, one hand at the front and clip the three elastics that went through the crack of the seat. These will connect to the elastics at the front of the seat.
Be careful, there may be grease on the rails. The last clip is from the outside to the inside of the seat, this is when the extension elastic will be most useful. It will go between the fabric and plastic panel then under the seat to clip together underneath. Then make sure the cover is fitting well, if not wriggle into place.
The headrest covers are labelled “front”, evenly slide the headrest cover on then close the velcro’s.
Trim off excess velcro if needed. Now return the headrests to the seat.
Over time the base of the seat cover can ride forward. This can put stress on the seat cover where it joins the top and base. In order to prevent this wriggle the base of the seat cover back so that the sheepskin sits in the crack of the seat.
With the new Toyota Land Cruiser’s and Sahara’s 2016 onwards, the elastics at the front of the base of the seat cover are to be threaded with the help of the extension elastic between the plastic panel and material on the seat. This will give a nice snug fit. Do not stretch the elastics over the 10cm plastic panel as this will cause the seat cover base to pull forward.
The best way to clean your sheepskin car seat covers is to vacuum, the more the better.
We recommend to dry clean only if your covers need a thorough cleaning.
These sheepskin car seat covers have not being tested or approved by any governing authorities. If for any reason the side airbag fails to deploy, the manufacture Sheepskin Tailors will not be held responsible. The opening for the airbag must always be left open and not covered or sewn together. Please note “drivers” and “passengers” labels inside the sheepskin seat covers are to be put on the correct seats. Covers may not be swapped around and are tailored to the car for which they were purchased. If you wish to put them on another vehicle you do this at your own risk.
For more information click here. Thanks for reading through our sheepskin car seat covers care guide.
THERE IS NO DELIVERY CHARGE WITHIN AUSTRALIA
DELIVERY FOR CAR SEAT COVERS 14-28 DAYS
TO ORDER PHONE 7 DAYS ON 1300 65 37 32
PO BOX 1164 MOUNT GAMBIER SA 5290